|
|
|
GLIDECAM X-10
Email Us
for Offer |
|
The GLIDECAM X-10 System includes:
1.
Glidecam X-10 Support Arm
2. Glidecam Support Vest
3. Docking Bracket
4. Stainless Steel Arm Post (1)
5. Aluminum Arm Post (1)
6. Steel Weight Plates (6)
7. Hardware and Operations Manual. |
|
 Back
|
|
Glidecam X-10 Support Arm
Email
Us for Offer |
|
The GLIDECAM X-10’s Dyna-Elastic™
Dual-Articulating Support Arm incorporates 38 precision radial bearings within
its machined T6 aluminum structure. The placement and implementation of these
double-shielded bearings produce minimal friction and allow the Dyna-Elastic™
Support Arm to pivot and boom very smoothly, and with virtually no noise.
Four high-carbon alloy, Extension Springs are employed within the Support Arm’s
hardcoat anodized Exo-Skeletal Shells. Utilizing Class Three Levers, the energy
of the Extension Springs acts upon internal Fulcrum Points, and provides the
Support Arm with its lifting power. The spring tension is field adjustable and
allows for varying camera weights.
Our proprietary spring Inter-X-Change™ system makes the installation and removal
of the springs quick and easy. The Support Arm can be setup and used in either a
Two-Spring Mode, or a Four-Spring Mode. In the Two-Spring Mode, the Support Arm
can hold a total combined camera and hand-held stabilizer weight of 9 pounds. In
the Four-Spring Mode, the Support Arm can hold a total combined camera and
hand-held stabilizer weight of 18 pounds.
A key design feature of the Support Arm is that it incorporates our Light-Force™
technology. This literally means that only a "light" force or effort is required
by the operator to hold the arm at any given position, or to boom the arm up and
down. It is this Light-ForceTM feature that provides the operator with the
optimum amount of camera buoyancy or float. |
|
|
|
Glidecam X-10 Support Vest
Email
Us for Offer |
|
The Glidecam X-10 Support Vest is lightweight, comfortable and can be adjusted
to fit a wide range of operators. High endurance, dual density, EVA foam padding
and integral T6 aluminum alloy create a vest which can hold and evenly
distribute the weight of the system across the operator's shoulders, back, and
hips. For safety, quick release, high impact buckles allow the vest to be
removed quickly. The Vest’s outer shell is made of 1000 denier cordura fabric,
and 7-panel seat belt strapping, noted as being the best in the industry.
The Glidecam X-10 Support Vest incorporates a unique and proprietary Arm-to-Vest
Connector that allows the angle of the Support Arm to be adjusted relative to
the Support Vest. This Trimming Mechanism allows you to neutralize the weight of
the Support Arm relative to your body’s center of gravity. When set correctly
the effort required while shooting is greatly reduced. Another unique and
proprietary feature of the Arm-to-Vest Connector is that it allows the Support
Arm to be attached and removed from the Vest without affecting the operator’s
selected trim settings. |
 |
Back
GLIDECAM PRICELIST
|
|
