Azden Pro Audio System - UHF Wireless System 200ULX


	AZDEN 200ULX Dual 63-Channel On-Camera UHF Wireless Plug-In System 200ULX

	The 200ULX is a complete dual-channel wireless system that consists of the 200UPR receiver and one each 51XT plug-in transmitter and 10BT bodypack transmitter. The new 200UPR receiver allows the use of two wireless transmitters at the same time. It features twin-antennas, a 3.5mm -64dbB 2-channel mic level output jack, two recessed On/Off switches, two Power On/ Signal Received LED and 2 sets of channel selectors to set the desired frequency for each receiver. Using crystal-control and PLL synthesis the 200UPR operates for better than 8 hours on 6 "AA" batteries. The receiver comes with a "hot-shoe" mount, a 2-channel 3.5mm to 3.5mm output cable and a 2-channel 3.5mm to twin XLR cable. Included is the 51XT frequency-agile UHF plug-in transmitter which convert wired low impedance mics into wireless microphones. The 63-channel user-switchable transmitter features separate Power On/Off (with LED indicator) and Audio Standby switches along with a mic input level control with Peak indicator and and a switch that supplies voltage to condenser microphones (Phantom Power). The 51XT is powered by a standard alkaline 9V battery and uses a special "lock-down" XLR connector to secure the microphone. Also included is the 10BT body-pack transmitter supplied with the Azden EX-503 omni-directional lapel microphone and a metal belt-clip. In addition to the 3.5mm mic input jack the transmitter has a Power On switch with an associated LED a separate Standby switch for audio muting and a set of channel selector switches. The 10BT runs better than 8 hours on a single 9V battery. 200UPR Receiver Frequency Range UHF 63-Channel Selectable (793.750 � 805.875MHz) Type of Reception 2 Channel Receiver Oscillator PLL Synthesized RF Squelch Level 13dB�V Frequency Response 50Hz � 15kHz S/N Ratio >70dB �A� Weighted Audio Distortion <1% @ 1kHz Operating Temp. 0�C � 45�C (32�F � 113�F) MIC Out -64dBm @ 600 W - 3.5mm Mini-Jack Power Requirement 6 � 1.5V �AA� Alkaline Batteries or 12VDC @ 200mA - 6 � 8 Hours Dimensions 105W x 105H x 35D mm (4.13W x 4.13H x 1.38D inches) Weight Approx. 490g Including Battery (17.28oz) 51XT Transmitter Frequency Range UHF 63-Channel Selectable (793.750 � 805.875MHz) Antenna Internal Antenna Pre-emphasis 50 ms MAX Input Level -7dBm Microphone Unit Dynamic Microphones RF Output Power 15mW Input Impedance 6K Audio Adj Range -63dBm ~ -18dBm Battery 1-9V � 6-8 Hours Dimensions 40 x 40 x 99(L) mm (1.57 x 1.57 x3.9 inches) Weight 152g without battery (5.4oz) 10BT Transmitter Frequency Range UHF 63-Channel Selectable (793.750 � 805.875MHz) Oscillator PLL Synthesized RF Power 10mW Frequency Response 50Hz � 15kHz Max. Deviation �75kHz @ 1kHz Modulation, MIC Input �11dBm S/N Ratio >70dB �A� Weighted Audio Distortion <1% @ 1kHz MIC Sensitivity �40kHz @ -22dBm MIC Input (0dBm+0.775V) - 3.5mm Mini Jack Operating Temp. 0�C � 50�C (32�F � 122�F) Power Requirement 1 � 9V Alkaline Battery - 6 � 8 Hour Dimensions 62W x 100H x 22D mm (2.44W x 3.94H x 0.87D inches) Weight Approx. 120g Including Battery (4.23oz)