|
|
|
4017B-R
Shotgun Microphone w. Rycote® Windshield
DPA
Microphones has joined forces with Rycote® to develop
the DPA 4017 Shotgun/Rycote® Windshield Solution. The
strong suspension and windshield solution has been
designed specifically to take the DPA 4017B shotgun
mic’s compact size and light weight into consideration.
This kit provides everything an outside broadcaster,
journalist or location film maker could need for clear,
directional sound, regardless of the weather and
environmental conditions.
Included in the
box
DPA 4017B Shotgun premounted in Rycote® Suspension with
the Rycote® Windshield
DPA XLR cable
DPA Windscreen for 4017B
Rycote® fur windjammer
Rycote® XLR holder
Rycote® brush
. |
|
General Specifications |
|
Directional pattern: |
Supercardioid, lobe-shaped |
|
Principle of operation: |
Pressure gradient, with
interference tube |
|
Cartridge Type: |
Pre-polarized condenser |
|
Frequency range: |
20 Hz to 20 kHz |
|
Frequency range, ± 2 dB: |
70 Hz to 20 kHz, permanent
third order high pass filter at 50 Hz |
|
Sensitivity, nominal, ± 2 dB at 1 kHz: |
19 mV/Pa; -34.4 dB re. 1 V/Pa |
|
Equivalent noise level, A-weighted: |
Typ. 14 dB(A) re. 20 µPa
(max. 15 dB(A)) |
|
Equivalent noise level, ITU-R BS.468-4: |
Typ. 25 dB (max. 26 dB) |
|
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): |
Typ. 80 dB(A) |
|
Total Harmonic Distortion (THD) at 1 kHz: |
< 1 % up to 133 dB SPL
peak |
|
Filters: |
High boost: +4 dB at 8
kHz. Low cut: First order filter, below 120 Hz |
|
Dynamic range: |
Typ. 119dB |
|
Max. SPL, peak before clipping: |
152 dB |
|
Output impedance: |
<150 ohm |
|
Cable drive capability: |
100 m (328 ft) |
|
Output balance principle: |
Signal balanced |
|
Common Mode Rejection Ratio (CMRR): |
> 40 dB |
|
Power supply (for full specifications): |
48 V Phantom power (± 4 V) |
|
Current consumption: |
4.5 mA |
|
Color: |
Matte black |
|
Weight: |
68 g (2.4 oz) |
|
Diameter: |
19 mm (0.75
in) |
|
Capsule diameter: |
19 mm (0.75 in) |
|
Output voltage, RMS: |
> 1.8 V |
|
Microphone Length: |
212 mm (8.3 in) |
|
Polarity: |
+V at Pin 2 for positive
sound pressure |
|
Connector: |
XLR-3M. Pin 1: shield, Pin
2: signal + phase, Pin 3: - phase |
|
Relative Humidity (RH): |
Up to 90% |
|
Temperature range: |
-40 °C to 45 °C (-40 °F to
113 °F) |
|
Minimum load impedance: |
2 kohm |
|
| |
|
|
|
