Offer Yamaha Stereo Power Amps

General Specifications
			PC9501N	PC6501N	PC4801N	PC3301N	PC2001N
Output power AC120V model AC240V model	1kHz THD+N =1%	8ohms	1000Wx2	700Wx2	550Wx2	350Wx2	230Wx2
		4ohms	1600Wx2	1100Wx2	850Wx2	600Wx2	400Wx2
		8ohms bridge	3200W	2200W	1700W	1200W	800W
	20Hz- 20kHz THD+N =0.1%	8ohms	925Wx2	650Wx2	475Wx2	330Wx2	200Wx2
		4ohms	1400Wx2	930Wx2	725Wx2	525Wx2	325Wx2
		8ohms bridge	2800W	1860W	1450W	1050W	650W
		100V bridge	-	-	-	625W(16ohms)	-
	1kHz (20ms non-clip)	2ohms	2300Wx2	1500Wx2	1200Wx2	800Wx2	500Wx2
		4ohms	4600W	3000W	2400W	1600W	1000W
Output power AC230V model	1kHz THD+N =1%	8ohms	1050Wx2	1050Wx2	500Wx2	400Wx2	250Wx2
		4ohms	1650Wx2	1150Wx2	800Wx2	700Wx2	450Wx2
		8ohms bridge	3300W	2300W	1600W	1400W	900W
	20Hz- 20kHz THD+N =0.1%	8ohms	950Wx2	650Wx2	450Wx2	350Wx2	230Wx2
		4ohms	1500Wx2	930Wx2	700Wx2	550Wx2	400Wx2
		8ohms bridge	3000W	1860W	1400W	1100W	800W
		100V bridge	-	-	-	625W(16ohms)	-
	1kHz (20ms non-clip)	2ohms	2300Wx2	1600Wx2	1200Wx2	900Wx2	600Wx2
		4ohms	4600W	3200W	2400W	1800W	1200W
Power Bandwidth	Half Power		10Hz-40kHz(THD+N=0.5%)
Total harmonic distortion	Half Power		0.1%, 20Hz-20kHz
Intermodulation distortion	Half Power		0.1%, 60Hz:7kHz=4:1
Frequency response			0dB (max, typ), -1dB (min) / 20Hz-50kHz
Channel separation	Half Power, Att. Max Input 600ohmsshunt		≥70dB 1kHz, RL=8ohms
Residual noise	DIN AUDIO		≤-70dB 20Hz-20kHz
S/N ratio	DIN AUDIO		106dB	105dB	103dB	101dB	100dB
InputSensitivity	Att. Max	@8ohms	+9dB	+8dB	+6dB	+4.5dB	+3dB
Maximum voltage gain	Att. Max		32dB
Maximum input voltage			+22dB
Actual load impedance			20kohms (balance), 10kohms (unbalance)
control	Front panel		POWER switch Attenuater (31 position) x 2
	Rear panel		MODE switch (STEREO/BRIDGE/PARALLEL) HPF switch (on/off, 20Hz 12dB/oct) AMP ID switch (6Pin DIP)
Connector	Input		XLR3-31 type /ch (balance) Euro-block type Terminal blocks /ch (balance)
	Output		SPEAKON /ch 5way binding post /ch
	Network		RJ45 x 2
	Power		AC inlet x 1
indicator	POWER/STAND-BY		x 1 (Green/Orange)
	PROTECTION		x 1 (Red)
	TEMP		x 1 (Red), Heatsink temp ≥ 85degrees celsius
	REMOTE		x 1 (Green)
Levelmeter			10 points LED meter /ch
Protection			POWER switch ON/OFF mute DC-fault power supply shutdown Thermal (Heatsink temp≥90degrees celsius VI limitter (RL≤1ohm)
Limitter circuit			Clip Limiting:THD≥0.5%
Cooling			Dual Variable-speed fan
Power requirements			AC 100V 50/60Hz
Idle power consumption			55W	40W	40W	40W	40W
Power consumption	AC120V model		950W	700W	450W	450W	300W
	AC230V model		1100W	800W	600W	500W	350W
	AC240V model		1100W	800W	600W	500W	350W
Dimensions			480W x 88H x 456Dmm
Weight			13kg	12.5kg
0dB=0.775Vrms,0dBV=1.00Vrms Half Power=3dB below rated power