|
|
|
|
|
|
|
|
AZDEN APS 25-VH2 Powered Speaker System
(Discontinued) |
|
|
The APS 25-VH2 powered speaker system is a fully
self-contained wireless sound reinforcement system with two VHF wireless
handheld microphones.
Incorporating a 20 watt amplifier, the APS 25 is a rugged, 2-way speaker with a
5.25" shielded woofer and a 1" wide-dispersion tweeter that produces clear
detailed sound for all corporate, educational and commercial applications.
The APS 25 includes a Master Volume control and Tone control to reduce feedback.
Individual level controls for each of the four inputs- two wireless, one wired
mic level, and one line level-giving you more ways to configure your system. The
speaker's variable line level output lets you daisy chain multiple speakers. The
high gain mic input shorts automatically to reduce noise when no mic is plugged
in.
Included with the APS 25 is the Auto On-Off circuitry triggered by any audio
input signal for hands-off system startup; a high impact case for reliability,
and dual-voltage(110/220V) switching to facilitate installation and use. The
speaker can be used free standing, stand-mounted (5/8x27 threaded holes on the
bottom and side) or wall-mounted with the supplied U-mount bracket.
The APS 25-VH2 includes two APS-VR VHF receiver modules (choose from 25
frequencies below) and two 31HT microphone/transmitters.
Speaker Technical Specs:
Rated Power: 20 Watts continuous
Frequency Response: 65Hz – 18kHz
Max SPL @ Rated Output: 101db @ 1 meter
Woofer: 5.25" (133.35mm) high efficiency - magnetically shielded
Tweeter: 1" (25mm) dome
Crossover: 1st order passive @ 8kHz
Tone Control: -6dB/octave sliding low pass (3kHz to 8kHz)
Wireless Inputs: 2 user-installable receivers
VHF (169-213 MHz) – 30 fixed frequencies
UHF (566.25-589.75 MHz) – 92 user-selectable frequencies
Infrared – 2 fixed frequencies
Wired Inputs/Output:
Mic: -81dBv (0.089mVRMS) for 1 watt, 100K balanced, ¼" phone jack, variable
Line: -40dBv (10mVRMS) for 1 watt, 10K unbalanced, RCA jack, variable
Line-Out: +15dBv max - RCA jack
Weight: 8.5lb (3.85kg) approx. w/out receivers
Dimensions: 12.4"H X 7.09"W X 5.6"D (315 X 180 X 142mm)
Compliance: UL, C-UL, and FCC approved
AC Power Requirements: User switchable, 110-125 / 210-240VAC - 50Hz/60Hz
Included w/speaker: Removable wall-mount bracket with 2 screws, rubber
anti-rotate pads, removable right-angle, AC cord, 4 self-adhesive anti-skid
pads, 4 module screws, 1 or 2 noise-canceling circuit boards (depending on how
many modules are installed
Receiver Technical Specs:
Frequency Range: 25 VHF channels (169.505-195.975MHz)
Frequency Response: 40Hz - 18kHz
S/N Ratio: better than 95dB (A weighted)
Operating Temperature Range: 0 - 45 C (32 - 113 F)
Operating Range: approx 100m (ideal-line of sight)
Oscillator: Crystal Controlled
Receiver Type: Super Heterodyne
Image Rejection: Better than 60dB
RF Sensitivity: -95dBm @ 50dB S/N
Audio Output Impedance: 2.2k ohms
Power Requirements: 10 - 16VDC
Transmitter Technical Specs:
Frequency Range: 25 VHF Channels (169.505 - 197.325 MHz)
Frequency Response: 40Hz to 18KHz (+/- 3dB)
Audio Distortion: less than 1.0% (± 15K deviation)
Dynamic Range: better than 100dB
S/N Ratio: better than 95dB
Operating Temperatures: 0° C to 45° C
Operating Range: 100m under ideal conditions
Oscillator: Crystal Controlled
Type of Emission: FM
Antenna: Internal Antenna
Microphone Unit: Unidirectional Dynamic
RF Output Power: 10mW
Input Impedance: 8 ohms
Audio Adj. Range: n/a
Battery: 1 (AA)
Battery Life: 8 to 10 Hours with Alkaline Battery
Dimensions: 62mm(ø) 221mm(L) - (2.4" x 8.3")
Weight: 213g (7.5 oz) Without Battery |
 |
|
|
|
|
>
AZDEN >
AC and Battery Speakers
> APS 25-VH2
