Tempest TMP-RT24 Tempest2400 Remote Transceiver

tempest2400 TMP-RT24 Remote Transceiver
TMP-RT24 Tempest2400 Remote Transceiver   

Tempest2400 Remote Transceiver with Omni Antenna

Product Code: TMP-RT24

Tempest2400 Remote Transceiver


  • Allows remote location of antennas from the base with no RF signal loss
  • Cable runs of up to 1500 ft. (450 m)
  • Operates on standard CAT 5/6 cable
  • Power is provided over the cable from BaseStation
  • Durable aluminum alloy enclosure
  • Weather-resistant for outdoor use,Rx, Tx, Sync, Config, and Power LED indicators
  • RP-TNC antenna connectors (2)
  • Includes two omni-directional 2 dBi antennas
  • Can remote antennas from the Transceiver with low loss coaxial cable
  • RoHS compliant

The Tempest®2400 Remote TransceiverY51 allows the Tempest2400 BaseStation antenna to be located up to 1500 ft (450m) from the BaseStation without any loss of RF signal. The RT is connected to the BaseStation via a standard CAT-5/6 cable using RJ-45 connectors. Power is provided over the CAT-5/6 cable so that no local power is required for the Remote Transceiver to operate normally. The RT is constructed of aluminum alloy. It comes with a universal mounting plate that can be used to mount the transceiver to poles, walls or other desired areas.

One Remote Transceiver can be connected to a single Tempest BaseStation (2- or 4-channel). A direct connection is required. (The transceiver will not operate properly if connected to a Local Area Network (LAN) or routed through a network device such as a router or switch.) The transceiver has two RP-TNC antenna connectors on top of the enclosure that can attach the standard 2dBi omni-directional antennas, or employ optional directional antenna via low loss coaxial cable.

The Remote Transceiver is weather resistant and is intended for use outdoors. It is recommended, however, that in extreme weather conditions appropriate measure are taken to ensure that no water enters into the enclosure.

System Specifiations
RF Frequency     2400 to 2480 MHz
RF Scheme FHSS with TDMA
Effective Radiated Power 100mW using 2dBi antenna
Receiver Sensitivity -93 dBm for 10-5 BER
Radio Certification FCC Part 15, Canadian RSS-210, license free
Transmission Range 1,000 ft. (304.8 m) under ideal conditions. 500 ft. to 900 ft. (152.4 m to 274.3 m) typical
Audio Dynamic Range >94 dB
Audio Frequency Response 300Hz–3.8KHz with proprietary audio voice shaping
System Latency Less than 50 ms direct
RoHS Compliant Yes
BeltStation Specifications
Maximum Distance, Base to Transceiver 1,500 ft (457.2 m), powered from the BaseStation
Connection to BaseStation CAT-5 standard wiring
BaseStations Supported per Transceiver 1
Number of Antenna Ports per Transceiver 2
Antenna Connector Type RP-TNC
Supplied Antenna Whip antenna (2)
Dimensions with Antennas (inches) H 12 in. × W 3.7 in. × D 1.7 in. (30.5 cm × 9.4 cm × 4.3 cm)
Weight 11 oz (312 g)
Operating Environment -20° to 50° C (-4° to 122° F); 10% to 90% Humidity
  • Antenna (x2)
  • Universal Mounting Plate with screws (x2)
  • 15 ft. (4.57m) CAT-5e Ethernet Cable