| The Extron IPL T PC1i AC Power
and Device Controller features a single AC power outlet,
bidirectional RS-232, IR output, and a contact closure input. The
IPL T PC1i integrates Ethernet technology into systems, enabling
flexible, centralized, Web-based power and device
management. |
• Web-based
remote AC power and device control with scheduling
• One female IEC power outlet — The AC power outlet can
be controlled remotely from any Web browser and scheduled for
automatic powering ON or OFF daily.
• One bidirectional RS-232 serial port — For remotely
and proactively monitoring and troubleshooting a projector,
flat-panel display, or other serially controlled device.
• One IR port — For controlling a professional or
consumer device that is controllable only through IR, such as a DVD
player.
• One contact closure input for detecting a switch closure
— Can be used to trigger an action, such as sound an alarm
when a door is opened or when a motion detector detects
movement.
• E-mail notification enables proactive support —
Technical support administrators and others can receive failure and
service messages through an e-mail enabled cell phone, PDA, pager,
or Internet e-mail account.
• Integral high-performance Web server — The IPL T PC1
and IPL T PC1i feature a built-in Web server with memory available
for storing device drivers, GlobalViewer, and custom user Web
pages.
• AC outlet status is retained during power loss — The
internal memory of the IPL T PC1 and IPL T PC1i is unaffected with
power loss, ensuring that only a device that was on before the
outage will be restarted. All user defined settings are retained in
the event of power outage.
• Front panel security lockout — If used in an
unsecured environment where easy access is undesirable, a security
lock-out feature may be implemented. During lock-out mode, a
special button combination is required to operate the front
panel.
• Supports industry standard communications protocols —
All IP Link models use industry standard communication protocols,
including ARP, ICMP, IP, TCP, UDP, DHCP, HTTP, SMTP, and
Telnet.
• Simultaneous multi-user support — Each IP Link device
supports multiple concurrent users, improving system
throughput.
• Multiple levels of access with password protection —
User access level authorizes limited entry to only pre-designated
functions, while administrator access level permits full access to
advanced settings.
• Free, easy-to-use Global Configurator software —
Global Configurator software, a free Windows® based
configuration utility, makes product setup simple and intuitive
– no programming knowledge is required.
• Free GlobalViewer® Web-based AV resource management
application — When used with GlobalViewer, IP Link control
processors provide a powerful, flexible way to manage, monitor, and
control both Extron and third-party equipment like projectors,
plasmas, monitors, VCRs, DVD players, and other devices using a
standard TCP/IP network. |
| AC control interface |
| Connectors |
|
| IPL T
PC1 |
1 female USA/Edison power connector |
| IPL T
PC1i |
1 female IEC power connector |
| Voltage |
|
| IPL T
PC1 |
120 VAC, 50-60 Hz |
| IPL T
PC1i |
220 VAC, 50-60 Hz |
| Maximum AC
load |
|
| IPL T
PC1 |
12 A, 1440 watts at 120 VAC |
| IPL T
PC1i |
10 A, 2200 watts at 220 VAC |
| Serial control interface |
| Serial control
port |
(1) RS-232 only, 3.5 mm captive screw connector, 4
pole |
| Baud rate and
protocol |
115200 to 300 baud (9600 baud = default) ; 8 (default) or
7 data bits; 1(default) or 2 stop bits; no parity (default), or
even or odd parity |
| Serial control pin
configuration |
1 = Tx, 2 = Rx, 3 = GND, 4 = +5 VDC |
| Ethernet control interface |
| Connector |
1 female RJ-45 connector |
| Data
rate |
10/100Base-T, half/full duplex with
autodetect |
| Protocols |
ARP, ICMP (ping), IP, TCP, UDP, DHCP, HTTP, SMTP,
Telnet |
| Default
settings |
Link speed and duplex level = autodetected
IP address = 192.168.254.254
Subnet mask = 255.255.0.0
Gateway = 0.0.0.0
DHCP = off |
| Web
server |
Up to 200 simultaneous sessions
7.25 MB nonvolatile user memory |
| Program
control |
Extron Simple Instruction Set
(SIS™) |
| Global Viewer
requirements |
Microsoft® Internet Explorer ver. 6 or
higher |
| Contact closure interface — input
only |
| Quantity/type |
1 contact closure input |
| Contact input
control connector |
(1) 3.5 mm captive screw connector, 4 pole (shared with IR
output port) |
| Contact closure
(input only) |
|
| Input
voltage range |
0 to 5 VDC, clamped at +5.1 V |
| Input
impedance |
10k ohms |
| Threshold |
1.6 VDC |
| Pin
configuration |
1 = contact input, 2 = GND |
| IR control interface |
| IR control
port |
(1) 3.5 mm captive screw connector, 4 pole (shared with
contact closure input port) |
| Pin
configuration |
3 = S (IR signal output), 4 = GND |
| IR output carrier
frequency |
30 kHz to 1 MHz |
| General |
| Power
input |
Internal
100-240 VAC, 50-60 Hz
5 watts |
| IPL T
PC1 |
12 A (max.) |
| IPL T
PC1i |
10 A (max.) |
| Temperature/humidity |
Storage: -40 to +158 °F (-40 to +70 °C) / 10% to
90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%,
noncondensing |
| Cooling |
Convection, no vents |
| Mounting |
|
| Rack
mount |
Yes, with optional 1U rack shelf |
| Furniture
mount |
Yes, with optional under desk mounting kit |
| Enclosure
type |
Metal |
| Enclosure
dimensions |
1.7" H x 4.3" W x 6.0" D (1U high, quarter rack wide)
(4.3 cm H x 10.9 cm W x 15.2 cm D)
(Depth excludes connectors.) |
| Product
weight |
1.0 lbs (0.5 kg) |
| Shipping
weight |
3 lbs (2 kg) |
| Vibration |
ISTA 1A in carton (International Safe Transit
Association) |
| Regulatory
compliance |
|
| Safety |
|
| IPL
T PC1 |
CE, c-UL, UL |
| IPL
T PC1i |
CE |
| EMI/EMC |
CE, C-tick, FCC Class A, ICES, VCCI |
| Warranty |
3 years parts and labor |
| NOTE |
All nominal levels are at
±10%. |
|
|
| |
|
|
