Clear-Com FIM-202D module fiber interface

Clear-Com FIM-202D 2-Port Matrix frame to/from panel or module fiber interface (Dual fiber run.)

Product Code: FIM202D

The FIM-202D is an optical fiber interface for use with Eclipse Digital Matrix and Matrix Plus3 intercom systems. Each pair of FIM-202D fiber interfaces allow one or two digital matrix intercom panels or interface modules to be remotely connected to the matrix card frame via optical fibre.

This transmission capability allows a set of panels to be located remotely from the matrix frame using existing fiber cabling or can be used to temporarily locate panels via fiber in live event production applications. Panels may be connected to the matrix frame at fiber lengths of up to 12 miles (20 km) when used with single mode fiber. The use of fiber for long runs eliminates all types of electromagnetic and RF interference to the signal and provides an intrusion secure link.

Features of FIM202D

· Remotely locates one or two digital matrix panels or interface models over fiber
· 24-bit digital DEMUX
· 48kHz audio sampling rate
· Sends and receives RS-422 control data
· Flat frequency response up to 20kHz, S/N >80dB
· Up to 20km (12 miles) range with fiber using single mode
· Up to 5km (3 miles) using multi mode fiber
· Works in demanding environmental conditions
· RJ-45 connectors for direct connection with matrix panels, frames and interfaces
· Can be used to extend any line level 4-wire audio signal / RS-422 signal

Technical Details of FIM 202D

The FIM-202D can operate in demanding conditions, over a temperature range of -40 degrees to +65 degrees Centigrade and with humidity range of 0% to 95%, non-condensing.