|
The Glidecam Tru-Horizon is designed for 1 to 5 pounds (.45 to 2.26 kg.) cameras.
The Future is now. Take your moving shots to the next level with the Glidecam Tru-Horizon. Now you can move from low mode to high mode, and back again, in one single fluid shot while your camera automatically remains level and horizontal
at all times. The Glidecam Tru-Horizon can be attached to the Glidecam Devin Graham Signature Series, Glidecam HD-4000 and Glidecam XR-PRO and it will control your camera's roll axis giving you a True-Horizon.
Glidecam Tru-Horizon Motorized Gimbal
The motor work with position feedback, encoders, and the IMU sensor (Inertial Measurement Unit) to communicate with our custom 32-bit controller. Combining the accuracy of our sensors with the speed of the controller equals perfectly
stable video in all three axis with .02 degrees of accuracy. |
• Load Weight: 1-5 lbs. (.45 to 2.26 kg.)
• Angular Vibration Range: ±0.02°
• Roll Axis Control: 360°/s
• Motor Type: 1 x Brushless with factory pre-programmed AS5600 (I2C) Encoder
• Processing: 32-bit processor
• System Requirements: Windows: 32- or 64-bit
• Supported Camera Dimensions:
– Max Dimensions: 8" width, 12" length, and 6" height.
– No more than 4" of clearance from the back of the camera to the mounting hole.
• Power Requirements: 1x BP-U30 Battery (Included)
• Operating Temperature: 15 to 105°F (sensor performs best when not below freezing, 32 degrees F.)
• Built in slip-ring allowing 360 degree rotations of the motor without twisting wires. |
|
|
