|
DPA d:dicate� MMP-E Modular Active Cable |
|
Product Code:
MMPE
|
|
MMP-ER |
|
Modular Active Cable, 3m, Rear Cable |
 |
|
|
MMP-ES |
|
Modular Active Cable, 3m, Side Cable |
|
|
To be used with hanging mics or low-profile
table or instrument mics, the MMP-E preamps can be combined with any d:dicate
modular capsule. The MMP-E features a high quality preamp, split into a 12mm
housing and a 3-pin XLR connector. These components attach the capsule to a
cable at a length of 3 meters or optionally up to 30 meters. The preamp is ultra
transparent and features the DPA designed impedance balancing with active drive
to reject radio frequency interference.
The cables are available with rear or side cable entry. |
|
Output
connector: |
XLR-3M. Pin 1: shield, Pin 2:
signal + phase, Pin 3: - phase |
|
Low-cut frequency, -3 dB: |
15
Hz |
|
Noise
with shorted input, A-weighted: |
0.6 µV |
|
Output voltage, RMS: |
2.2
V |
|
Output
voltage, peak: |
3.1 V |
|
Type of electronic circuit: |
Active |
|
THD@1VRMS, 1kHz: |
< 0.2 % |
|
Dynamic range: |
131
dB |
|
Cable drive capability: |
100 m (324
ft) |
|
Output impedance: |
100
ohm |
|
Output balance
principle: |
Impedance balancing |
|
Common Mode
Rejection Ratio (CMRR): |
> 40
dB |
|
Power supply (for full
specifications): |
48 V Phantom power (± 4
V) |
|
Current
consumption: |
3.5 mA |
|
Temperature
range: |
-40 °C to 45 °C (-40
°F to 113 °F) |
|
Color: |
Matte
black |
|
Weight: |
91 g (3.2 oz) |
|
Diameter: |
19 mm (0.75
in) |
|
Length: |
3 m (9.8 ft) |
|
Relative Humidity (RH): |
Up to
90% |
|
|
|
|
|
