Audio Technica ATM710 Cardioid Condenser Handheld Microphone
Product Code: ATM710
Features
• Excels in venues with controlled stage volume or in-ear monitoring
• Superior anti-shock engineering for low handling noise
• Condenser design for studio-quality performance
• Integral 80 Hz HPF switch and 10 dB pad switch
• Rugged, all-metal design and construction
• Quiet-FlexTM stand clamp provides silent, exible microphone positioning
This electret singing microphone from the Artist Series range is designed for detailed and faithful voice reproduction. With a capacitor designed for
studio-quality performance, the ATM710 provides remarkable clarity. This microphone is equipped with an integral 80Hz low-cut filter that allows easy switching from a flat frequency
response to severe attenuation position which reduces the sensitivity of the microphone "pops" when used in proximity to voice. The ATM710 is also equipped with a 10 dB switchable
attenuator that reduces the sensitivity of the microphone and provides superior SPL capacity. The cardioid microphone improves isolation of the sound source and reduces pickup of sounds to the sides and rear. |
| Element |
Fixed-charge back plate, permanently polarized condenser |
| Polar Pattern |
Cardioid |
| Frequency Response |
40 - 20,000 Hz |
| Open Circuit Sensitivity |
–40 dB (10.0 mV) re 1V at 1 Pa |
| Impedance |
200 ohms |
| Maximum Input Sound Level |
148 dB SPL, 1 kHz at 1% T.H.D.; 158 dB SPL, with 10 dB pad (nominal) |
| Low Frequencey Roll Off |
80 Hz, 12 dB/octave |
| Dynamci Range |
127 dB, 1 kHz at Max SPL |
| Signal to Noise Ratio |
73 dB, 1 kHz at 1 Pa |
| Phantom Power Reqirements |
11-52V DC, 3 mA typical |
| Weight |
274 g |
| Dimensions |
179.0 mm (7.05") long, 50.0 mm (1.97") diameter |
| Output Connector |
Integral 3-pin XLRM-type |
| Accessories |
AT8470 Quiet-Flex® stand clamp for 5/8"-27 threaded stands; 5/8"-27 to 3/8"-16 threaded adapter; soft protective pouch |
|
|
