Audio Technica AT898 Subminiature Cardioid Condenser Microphone
Product Code: AT898
Features
• Designed to be worn as a lavalier or hidden in clothing
• Offers maximum intelligibility and accurate voice reproduction
• Unobtrusive appearance for use in broadcast studios, theatres, etc.
• Low frequency roll-off reduces sensitivity to popping
• Operates on battery or phantom power
• 3m cable permanently attached to mic, TA3F connector at power module
Designed to be worn as a lavalier or hidden in clothing, Audio-Technica's discreet-design cardioid AT898 offers maximum intelligibility, accurate voice
reproduction and unobtrusive appearance for use in houses of worship, broadcast studios, theaters, etc. Its switchable low-frequency roll-off reduces sensitivity to popping. Battery
or phantom power. |
| Element |
Fixed-charge back plate permanently polarized condenser |
| Polar Pattern |
Cardioid |
| Frequency Response |
200 - 15,000 Hz |
| Low Frequency Roll-Off |
80 Hz, 12 dB/octave |
| Open Circuit Sensitivity |
Phantom : –43dB (7.0mV), re 1V at 1Pa - Battery : 46dB (5,0mV), re 1V at 1Pa |
| Impedance |
Phantom 200 Ω - Battery 250 Ω |
| Maximum Input Sound Level |
Phantom: 131 dB SPL, 1 kHz at 1% T.H.D. - Battery: 115 dB SPL, 1 kHz at 1% T.H.D. |
| Dynamic Range |
Phantom: 100dB,1 kHz at max SPL - Battery: 84dB, 1 kHz at max SPL |
| Signal to Noise Ratio |
63 dB, 1 kHz at 1 Pa |
| Phantom Power Requirements |
11-52V DC, 2 mA typical |
| Battery Type |
1.5V AA/UM3 |
| Battery current life |
0.4 mA / 1200 hours typical (alkaline) |
| Switch |
Flat, roll-off (recessed) |
| Weight |
Microphone: 0.9 g
Power module: 102 g |
| Dimensions |
Microphone 23.0 mm long, 5.3 mm diameter - Power Module 145.0 mm long, 21.0 mm diameter |
| Output Connector |
Integral 3-pin XLRM-type |
| Cable |
3.0 m long (permanently attached to microphone), 2.0 mm diameter, 2-conductor, shielded cable with TA3F output connector that mates with TB3M jack on power module |
| Accessories |
AT8537 power module; AT8439 cable clip; clothing clip base; viper clip base; magnet clip base and plate with lanyard; three single
mic holders; two double mic holders; two windscreens;
battery; protective carrying case |
|
|
