• Excellent RF Immunity
• Lightweight
• Uniform off-axis response
• Highly directional
Setting new standards for compactness within shotgun microphones
and their applications, the modular 4017C is an exceptionally short
and lightweight interference tube microphone with high
directionality. The tight polar pattern is very frequency linear
and uniform. With the compact MMP-C pre-amp, booming applications
such as in a car or in low ceiling rooms is uncomplicated. The
total length of the microphone is as short as 15,4 cm (6.1 in), the
weight at just 70 g (2.5 oz).
Also available with Rycote Windshield and suspension system, the
4017C-R is a fully packed and ready solution. |
| Directional pattern: |
Supercardioid,
lobe-shaped |
| Principle of operation: |
Pressure gradient, with
interference tube |
| Cartridge Type: |
Pre-polarized
condenser |
| Frequency range: |
20 Hz to 20
kHz |
| Frequency range, ± 2
dB: |
40 Hz - 18 kHz with
typ. 3 dB soft boost at 15 kHz |
| Sensitivity, nominal, ± 2 dB at 1
kHz: |
19 mV/Pa; -34.4 dB
re. 1 V/Pa |
| Equivalent noise level,
A-weighted: |
Typ. 13 dB(A) re. 20
µPa (max. 15 dB(A)) |
| Equivalent noise level, ITU-R
BS.468-4: |
Typ. 24 dB (max. 26
dB) |
| S/N ratio (A-weighted), re. 1 kHz at 1
Pa (94 dB SPL): |
Typ. 80
dB(A) |
| Total Harmonic Distortion (THD) at 1
kHz: |
< 1 % up to 133 dB
SPL peak |
| Dynamic range: |
Typ.
119dB |
| Max. SPL, peak before
clipping: |
146dB |
| Output impedance: |
100
ohm |
| Minimum load
impedance: |
2 kΩ |
| Cable drive
capability: |
100 m (328
ft) |
| Output balance principle: |
Impedance balancing
with Active Drive |
| Common Mode Rejection Ratio
(CMRR): |
> 40
dB |
| Power supply (for full
specifications): |
48 V Phantom power
(± 4 V) |
| Current consumption: |
2.8
mA |
| Color: |
Matte
black |
| Weight: |
70 g (2.5 oz) |
| Diameter: |
19 mm (0.75
in) |
| Capsule diameter: |
19 mm (0.75
in) |
| Output voltage, RMS: |
4.5
V |
| Microphone Length: |
154 mm (6.1
in) |
| Polarity: |
+V at Pin 2 for
positive sound pressure |
| Connector: |
XLR-3M. Pin 1: shield,
Pin 2: signal + phase, Pin 3: - phase |
|
Relative Humidity
(RH): |
Up to
90% |
| Temperature range: |
-40 °C to 45
°C (-40 °F to 113 °F) |
|
|
|
